Welcome Guest ( Log In | Register )

 
Reply to this topicStart new topic
> rebuilding entire body panels in PS?
bmwaddicted49
post Dec 8 2010, 01:36 PM
Post #1


Shift Noob
*

Group: Members
Posts: 57
Joined: 1-February 10
Member No.: 5,242



So in certain situations, say a rig shot where you have a pole in front of the car/ coming off the hood, or say theres a dent you want to remove in PS, or maybe theres a reflection in the door you want to take out- how do you go about painting in new information and having it look natural and match with the rest of the car in terms of density and color and gradations?

any help would be greatly appreciated!!
Go to the top of the page
 
+Quote Post
Nike SB'd
post Dec 8 2010, 02:22 PM
Post #2


Pit Mechanic
***

Group: Members
Posts: 1,563
Joined: 12-July 07
Member No.: 3,959



Create a new layer and grab the highest key section and lowest key section and draw an initial gradient. If you then have additional tinting that's needed (say a horizontal color shift in addition to a vertical) add your secondary tinting. Once that's complete begin masking. Finally once masked you'll want to add some noise to the gradient, otherwise it looks "too fake" - I find that .3 -.5 usually works best depending on the paint (i.e. metallic needs more noise than flat). I will then usually add a very subtle gaussian blur to the noise to make it look like actual camera data instead of photoshop noise. Again usually a .3 blur works best. If there are additional colors that your gradient missed you can try lowering the opacity a bit and then just go in and retouch/clone to make it perfect. Overall it just takes practice, I've been doing this for about two years now and I have my methods down to a science.
Go to the top of the page
 
+Quote Post
iLLuZioNz
post Dec 17 2010, 06:14 AM
Post #3


Grease Monkey
**

Group: Members
Posts: 199
Joined: 2-August 10
From: Anywhere, GA
Member No.: 5,637



^this is really healpful info thanks man, havent run into this problem yet as I tend to put the camera under the rig but its nice to know that, at least initially, rebuilding panels doesnt seem as intimidating.
Go to the top of the page
 
+Quote Post

Reply to this topicStart new topic

 



RSS Lo-Fi Version Time is now: 31st October 2020 - 01:41 PM
IPS Driver Error

IPS Driver Error

There appears to be an error with the database.
You can try to refresh the page by clicking here